GA1000 Wi-Fi Add-on Module


The GA1000 Wi-Fi add-on module further expands the capabilities of Tibbo's BASIC/C-programmable devices by adding 802.11b/g communications to the already powerful hardware mix.

The GA1000 is compatible with the following products*: DS1101, DS1102, EM500, EM1000, EM1001, EM1206, EM2000, EM2001, TPP2, TPP2(G2), TPP3, TPP3(G2), LTPP3*.

The module relies on the SPI interface and requires only 5 I/O lines to control.

The GA1000 has a chip antenna onboard and a connector for an additional external antenna.

Please note that the GA1000 is a slave device and cannot be used on its own.

*Use the GA1000L module for this board.



  • Implements 802.11b/g Wi-Fi standard.
  • Requires only five I/O lines to control.
  • Chip antenna onboard; coaxial connector for an external antenna.
  • Red status LED for scan/link indication.
  • Power: 280mA @ 3.3V (active state).
  • Dimensions (LxWxH): 42.0 x 19.0 x 6.7mm.
  • Prototyping-friendly 2.54mm (100mil) pin pitch.
  • Operating temperature range: -20 ~ +70C.
  • CE- and FCC-certified (see PDF links on the right).
  • FCC ID: XOJGA1000.

See Also:

  • EM2000 programmable IoT module
  • EM2001 programmable IoT board
  • EM1206 programmable IoT module
  • EM500 programmable IoT module
  • DS1101 programmable 3.5-channel RS232 Controller
  • DS1102 programmable 3-channel RS232/422/485 controller
  • TPP2 board, part of Tibbo Project System (TPS)
  • TPP3 board, part of Tibbo Project System (TPS)
  • LTPP3 board, part of Tibbo Project System (TPS)


The GA1000 is supported by a powerful wln object, which is included into the platforms of compatible Tibbo BASIC/C-programmable devices.

Our serial-over-IP (SoI) application also makes the full use of the GA1000 and Wi-Fi communications.

Files and Documentation

GA1000 binary file* ga1000fw.bin
Documentation GA1000 Hardware Manual
CE Certificatesem1206_ev-ga1000-ce_rtte.pdf
(EMC and RTTE)
(low-voltage certification)
FCC Certificatesga1000-fcc-ext.pdf (with external antenna)
ga1000-fcc-chip.pdf (with onboard antenna)

* You will need this file only when creating Wi-Fi-enabled Tibbo BASIC/C applications.

Order the GA1000

The GA1000 add-on is a slave device and cannot be used on its own.
The module will only work with compatible Tibbo products.