GA1000

GA1000 Wi-Fi Add-on Module

The GA1000 add-on is a slave device and cannot be used on its own.
The module will only work with compatible Tibbo products.

The GA1000 Wi-Fi add-on further expands the capabilities of Tibbo's BASIC/C-programmable and serial-over-IP products by adding 802.11b/g communications to the already powerful hardware mix.

The GA1000 is compatible with the following devices*: EM1000, EM1206, EM500, EM1001, DS1001, DS1002, TPP2, TPP3.

The module relies on the SPI interface and requires only 5 I/O lines to control.

The GA1000 has a chip antenna onboard and a connector for an additional external antenna.

* Please note that the GA1000 is a slave device and cannot be used on its own. The GA1000 will only work with compatible Tibbo products.

Hardware

Specification:

  • Implements 802.11b/g Wi-Fi standard.
  • Requires only five I/O lines to control.
  • Chip antenna onboard, coaxial connector for an external antenna.
  • Red status LED for scan/link indication.
  • Power: 280mA @ 3.3V (active state).
  • Dimensions (LxWxH): 42.0x19.0x6.7mm.
  • Prototyping-friendly 2.54mm (100mil) pin pitch.
  • Operating temperature range: -20 ~ +70C.
  • CE- and FCC-certified (see PDF links on the right).
  • FCC ID: XOJGA1000.

See Also:

  • EM1000 programmable IoT module
  • EM1206 programmable IoT module
  • EM500 programmable IoT module
  • EM1001 programmable IoT board
  • DS1001 programmable 3.5-channel RS232 Controller
  • DS1002 programmable 3-channel RS232/422/485 controller
  • TPP2 board, part of the Tibbo Project System (TPS)
  • TPP3 board, part of the Tibbo Project System (TPS)

Programming

The GA1000 is supported by a powerful wln object, which is included into the platforms of compatible BASIC/C-programmable devices.

Our serial-over-IP (SoI) application also makes the full use of the GA1000 and Wi-Fi communications.

Files and Documentation

GA1000 binary file*ga1000fw.bin
DocumentationGA1000 Hardware Manual
CE Certificatesem1206_ev-ga1000-ce_rtte.pdf
(EMC and RTTE)
em1206_ev-ga1000-ce-low_voltage.pdf
(low-voltage certification)
FCC Certificatesga1000-fcc-ext.pdf (with external antenna)
ga1000-fcc-chip.pdf (with onboard antenna)
* You will need this file only when creating Wi-Fi-enabled Tibbo BASIC/C applications.