* This is a Tibbo BASIC/C-programmable device and its function depends on the loaded app.
We offer many ready-to-use apps, among them a serial-over-IP (SoI) app, Modbus Gateway app, and Sensor Hub app.

Платы и комплекты разработчика для тестирования

Платы и комплекты, представленные на этой странице, позволяют протестировать и оценить работу модулей Tibbo. Некоторые платы достаточно компактны и подходят для серийных устройств.

EM2000EV Development BoardEM2000EV, shown with EM2000
(must be purchased separately)

EM2000EV Development Board

This evaluation board offers the bare essentials required for testing the EM2000 Tibbo BASIC/C-programmable IoT module. The board carries the sockets for the module, additional sockets for connecting to external circuitry, a power jack, and a power regulator, RJ45 jack (Ethernet port), MD button, and three status LEDs.

The EM2000 module is not included with the board and must be purchased separately.

For more information, see the EM2000EV documentation.

Система разработчика EM1000EV

Система разработчика EM1000EV

Идеальный инструмент для разработки и тестирования приложений нескольких последовательных портов на базе модуля EM1000 (с возможностью подключения дополнительного модуля Wi-Fi GA1000).

Состоит из материнской платы с размещённым на ней модулем EM1000, а также платой ввода/вывода с 4 RS232-портами.

За дополнительной информацией обратитесь к документации по EM1000EV.

EM1206SK Starter Kit

EM1206SK Starter Kit

The EM1206EV board plus accessories. The board comes with the RJ203+EM1206 module combination (soldered in) and, optionally, the GA1000 Wi-Fi add-on.

Also included on the board are the RJ45 jack with magnetics, power jack and regulator, one RS232 port with a DB9 connector, Wi-Fi add-on socket, LEDs, MD (setup) button, and a pin header for accessing the module's I/O pins.

For more information, see the EM1206EV documentation.

EM500EV Development System

EM500EV Development System

This kit is a two-board design consisting of a mainboard and an I/O board. The latter is available in two versions.

The mainboard carries a socket for the EM500 "MiniMo" module (included), RJ45 jack with magnetics, power jack and regulator, LEDs, and the MD (setup) button.

For more information, see the EM500EV documentation.

DS1206N

DS1206N

This is a DS1206 BASIC/C-programmable controller without a housing.

Ethernet connectivity. 3-channel RS232 port with power input/output on pin 9 of the DB9 connector.

Note: The DS1206N ships preloaded with the SoI app.